UL listed (with UL508a label) Mill Room Control Panel with Remote Mount Stop Button including the following. 1. (Qty.1 each) UL NEMA 4X Mill Room Control panel including the following: • Wiring schematic provided DPS based on request received and below assumptioNew listed • Hardware selection based on supplied control panels following same structure. • Proposal assumes 208/230VAC 3 phase with neutral (for 120VAC) for supply voltage to control panel • Completed control panel to include: o NEMA Type 4x wall mount enclosure with back panel o Main incoming 3 pole Non-fused disconnect switch through the door disconnect handle, and adder block for incoming Neutral wire connection o Roller Mill (RM1) 3hp, 208vac 3ph, 11fla Controls include: • 3pole din mount circuit breaker rated at 20amps • 16amp starter w/120VAC coil including adjustable overload (11-17FLA) • Green Illuminated Start Push Button • Red Non-Illuminated Stop Push Button • RM1 motor will not run unless Flex Auger AG1 is running o (3 (will be dependent on Flex Auger Qty. selected)) Flex Augers (AG1, AG2, AG3) 3/4hp, 230vac 3ph, 3.5fla Controls include: • (3) 3pole din mount circuit breakers rated at 10amps each • (3) 9amp starters w/120VAC coil including adjustable overload (4- 6.3FLA) • (3) Green Illuminated Start Push ButtoNew • (3) Red Non-Illuminated Stop Push ButtoNew o 120VAC Control Function to include: • 120VAC Single Pole din mount circuit breaker rated at 10amps • 2 position Control Power “OFF-ON†selector switch • 120VAC Ice Cube Relay wired for Field installed remote E-Stop to deenergize Control Panel • 120VAC White Control Power Pilot Light for Control Power indication • 120VAC Red Pilot light for indication of Remote Stop Push Button Pressed • DPS to supply phenolic labeling for door mounted devices based on layout example of previous project. • Control Panel field Terminal block interface for Control ConnectioNew • Customer source inspection included if requested prior to delivery. • Completed Control Panel to bare UL508a label BREWHOUSE CONTROL PANEL WITH 1 FLEX AUGER: $4273.28 ADDER OPTION: • DPS to supply for Customer install and wiring (1) Killark Remote Stop (E-STOP) Maintained Mushroom Head Single Hole PUSH-PULL Button Station for Hazardous locations: o Killark Model #FXCS-0MMR3 remote Push-Pull Station (Maintained) o Killark Model #FXB-2 Back Box for Push-Pull Station ADDER OPTION: $594.00 Total price- $4867.28 plus shipping – TBD
